The TO date time defaults to 00:00 in new Compliance Accelerator 14.x Searches
Article ID: 100052188
Updated On:
Description
Error Message
N/A.
Cause
A change was made to the date range picker to add the selection of the time in version 14.x and higher. The default time selection of the FROM date was also used for the TO date, thus resulting in the TO date time's default selection of 00:00.
Resolution
Two simple workarounds exist:
1. Edit the TO date time to 23:59 to reflect the end of the day.
2. Edit the TO date to one day ahead of the required date and leave the time at the default of 00:00.
There are no plans to address this issue by way of a patch or hotfix in earlier versions of the software at the present time. However, the issue has been addressed in the revision of the product specified at the end of this article.
Please contact your Veritas Sales representative or the Veritas Sales group for upgrade information including upgrade eligibility to the release containing the resolution for this issue.
This issue is fixed in the following release(s), available in the Download Center at www.veritas.com/support:
- Enterprise Vault 14.1.3 (downloadable here)
- Enterprise Vault 14.2.1 (download no longer available)
- Enterprise Vault 14.2.2 (downloadable here)
- Enterprise Vault 14.2.3 (downloadable here)
Issue/Introduction
Additional Information
